When This Type Of Copy Is Produced - Minolta CF9001 Operator's Manual

7-1

1. When This Type of Copy is Produced

When This Type of Copy is Produced
Symptom
The Image is too light.
The Image is too dark.
The Copy is blurry.
The Copy has dark specks or
spots.
Possible Cause
The manual exposure level is set
on the lighter side.
The message "Please add Toner."
is shown on the Touch Panel.
The paper is damp.
In cases other than the above.
1074O108
The manual exposure level is set
on the darker side.
The entire surface of the Original
Glass is dirty.
The original is not held tightly
against the Original Glass.
1074O109
In cases other than the above.
The paper is damp.
1074O110
The Original Glass is dirty.
The Original Pad or Document
Feed Belt is dirty.
The original is very thin or highly
transparent.
The original is two-sided.
1139O1660A
Action
Touch the Key as
Darker
necessary to obtain a darker
image. p.3-18
Replenish toner. p.6-3
Replace the paper. p.6-1
Refer to the "Gradation Adjust".
p.5-11
Touch the Key as
Lighter
necessary to obtain a lighter
image. p.3-18
Wipe the Glass clean with a soft
dry cloth. p.8-8
Place the original in position so
that it is held tightly against the
Glass. p.3-3
Refer to the "Gradation Adjust".
p.5-11
Replace the paper. p.6-1
Wipe the Glass clean with a soft
dry cloth. p.8-8
Wipe the Original Pad or
Document Transport Belt clean
with a soft cloth dampened with
mild detergent. p.8-7
Place a blank sheet of paper over
the original. p.3-3
The information on the back side
of a two-sided, thin original may
be slightly reproduced on the
copy. Touch the
Density
and set Background to
Lighter.
p.3-18
Key
or
Auto