Location Of Cooker; Conversion - Rangemaster Classic Deluxe 90 Dual Fuel User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.

Location of Cooker

The cooker may be installed in a kitchen/kitchen diner but
NOT in a room containing a bath or shower.
This appliance is designed for domestic cooking only. Use for
any other purpose could invalidate any warranty or liability
claim.
Note: An appliance for use on LPG must not be installed
in a room or internal space below ground level, e.g. in a
basement.

Conversion

This appliance is supplied set for G20 20 mbar Cat II 2H3+ .
A conversion kit for another gas is available for the cooker.
If the appliance is to be converted to another gas we
recommend that this is carried out before installation.
We recommend an overpressure shut-off device or
n
pressure relief valve be used in any LPG installation
to prevent exposure of downstream fittings /
appliances to excessive pressure (over 75mbar) in
event of regulator failure.
After converting the appliance, please attach the Gas
Conversion sticker over the appropriate area of the data
badge – this will identify the gas type for which the appliance
is now set.
You will need the following equipment to complete the
cooker installation satisfactorily:
• Stability bracket: If the cooker is to be supplied with gas
through a flexible hose, a stability bracket or chain must
be fitted. These are not supplied with the cooker but
are available at most builders' merchants.
• Gas pressure tester/manometer.
• Flexible gas hose: Must be in accordance with the
relevant standards.
• Multimeter: For electrical checks.
You will also need the following tools:
1. Electric drill
2.
Masonry drill bit (only required if fitting the cooker on a
stone or concrete floor)
3. Wall plugs (only required if fitting the cooker on a stone
or concrete floor)
4.
Steel tape measure
5. Cross head screwdriver
6.
Flat head screwdriver
7.
Spirit level
8. Pencil
9.
Adjustable spanner
10. Screws for fitting stability bracket
INSTALLATION
11. 4 mm & 3 mm Allen keys
Checking the Parts:
3 pan supports
Teppanyaki (Optional)
ArtNo.311-0043 - Griddle 09
Grill pan and trivet
Roasting tin
ArtNo.324-0004 Roasting tin
Tall oven shelves and shelf
supports
ArtNo.000-0010 Tall oven shelves
Splashback (Classic Deluxe)
Allen keys
32
Griddle plate (Supplied)
Wok cradle
ArtNo.000-0009 Wok ring, cast
2 flat shelves
Handyrack
ArtNo.324-0003 Handyrack
2-piece plinth
Stability location bracket
1x set of Telescopic runners
(Optional)