Technical Data Qr Code Module - Carrier LENEL S2 Manual

36
36
From the QR code reader
From the QR code reader
there are four wires, power
there are four wires, power
and communication to be
and communication to be
connected at the readers
connected at the readers
terminal blocks.
terminal blocks.
Connection cable QR code module
Connection cable QR code module

Technical data QR code module

Technical data QR code module
Sensor resolution
Illumination
Aiming
Symbologies
Resolution
Typical depth of field
Symbol contrast
Scan angel
Field of view
Operating voltage
Power consumption
Operating temperature
Relative humidity
Ambent light
Note that the connected LNL-R50360-04TB (without keypad) and
Note that the connected LNL-R50 x (5-6) x-xxxx reader must be
LNL-R50365-04TB (with Keypad) reader must be running on Firmware
running on Firmware 3.82.09 or higher to use the QR module as an
3.82.09 or higher to use the QR module as an accessory. Older firmware
accessory. Older firmware versions of LNL-R50x (5-6) x-xxxx readers
versions of LNL-R50360-04TB (without keypad) and LNL-R50365-04TB
will not detect the QR code reader. Settings can be done with LenelS2
(with Keypad readers will not detect the QR code reader. Settings can
Reader Tool LNL-R50000-tool version 6.5.0.7 or higher.
be done with LenelS2 Reader Tool LNL-R50000-tool version 6.5.0.7 or
higher.
Black wire GND
Black wire GND
Red wire DC+
Red wire DC+
Green wire D+/RX
Green wire D+/RX
White wire D-/TX
White wire D-/TX
640 horizontal x 480 vertical
White LED
None
QR code, micro QR and PDF417
Code 128, Code 39, Codabar, Interleaved 2 of 5, ITF-6, ITF-14
ISBN, Code 93, UCC/EAN-128, GS1 Databar, Matrix 2 of 5,
Code 11, Industrial 2 of 5, Plessey, MSI-Plessy
>3 mil
(QR 10 mil) 35 mm to 80 mm
25% min.
Roll: 360°, pitch: ±60°, skew ±60°
Horizontal 42°, vertical 31.5°
9 to 30 VDC
Current draw (Idle mode) 2.3 mA at 12 VDC, 1.2 mA at 24 VDC
-20 to +55°C
5 to 95% noncondensing
0 to 100,000 lx