NordicTrack T 4.0 User Manual page 8

3. Remove the M10 x 50mm Bolt (31), the M10 Nut
(19), and the shipping bracket (A) from the Base
(95). Attach a Wheel (97) with the Bolt and the
Nut that you just removed. Do not overtighten
the Nut; the Wheel must turn freely. Discard
the shipping bracket.
Press a Base Cap (87) into the Base (95).
4. Identify the Right Upright (89) and the Right
Upright Spacer (91), which are marked with
"Right" stickers.
Insert the Upright Wire (88) through the Right
Upright Spacer (91) as shown. Then, set the
Right Upright Spacer on the Base (95).
With the help of a second person, hold the Right
Upright (89) near the Base (95). See the inset
drawing. Tie the long tie in the Right Upright se-
curely around the end of the Upright Wire (88).
Then, pull the other end of the long tie until the
Upright Wire is routed completely through the
Right Upright.
5. Hold a Bolt Spacer (90) inside the lower end of
the Right Upright (89). Insert an M10 x 95mm
Patch Bolt (8) with an M10 Star Washer (9) into
the Right Upright and the Bolt Spacer. Repeat
this step with a second Bolt Spacer (90), an
M10 x 68mm Patch Bolt (114), and an M10
Star Washer (9).
Hold the Right Upright (89) against the Right
Upright Spacer (91). Be careful not to pinch
the Upright Wire (88). Tighten the M10 x 95mm
Patch Bolt (8) and the M10 x 68mm Patch Bolt
(114) until the heads of the Patch Bolts touch
the Right Upright; do not fully tighten the
Patch Bolts yet.
All manuals and user guides at all-guides.com
8
3
31
95
97
A
19
4
Long
88
89
Long
88
Tie
5
89
Tie
89
88
95
8
114
9
88
91
90
87
91