Canon XF605 Instruction Manual page 45

Icon/Display
4
Recording operation
Ü
STBY, REC
S&F STBY,
Ü
S&F REC
PRE STBY,
Ü
PRE REC
FRM STBY,
Ü
FRM REC,
Ü
FRM STBY
INT STBY,
Ü
INT REC,
Ü
INT WAIT
Ü
CONT, CONT
1s to 10m00s
`
00.00P, 00.00i
C
00:00:00.00 / 00:00:00:00
R, P, F, E
Power supply level indicator
 
è é
ê  ë 
(in red)
000 min
DC IN 00.0V
Right side of the screen
Icon/Display
60(24)fps,
60(30)fps
U
0000x0000
YCC000 00 bit
7 (in green)
(in red)
T
(in yellow)
(in yellow)
^ (in yellow)
J, K (in yellow)
Double slot recording (A 35).
Clip recording: record standby, recording.
Slow & fast motion recording (A 105): record standby, recording.
Pre-recording (A 107): record standby, recording.
Frame recording (A 107): record standby, recording.
Interval recording (A 108): record standby, recording.
Continuous recording (A 109)
Interval counter.
Recording command (A 145).
Frame rate (A 53).
When slow & fast motion recording is activated, the shooting frame rate is also
displayed (000/00.00P).
Key lock (A 15).
Time code (A 85).
Time code status (A 86).
Remaining battery charge of a BP-A30 or BP-A60 Battery Pack and estimated
remaining usage time (in minutes).
• When is displayed, replace the battery pack with a fully charged one.
• Depending on the conditions of use, the actual battery charge level may not be
indicated accurately or may not match the levels shown on the [B System
Setup] status screen or the indicators on the battery pack.
Power supply voltage when using an AC adapter.
• When the voltage falls below the selected low-power warning level (A 196),
the voltage will be displayed in red.
Video output (A 118).
Genlock (A 89).
Resolution (A 53).
Color depth, color sampling (A 53).
Photo recorded on the SD card (A 42).
No SD card or cannot record photos on the SD card.
Output onscreen displays (A 145).
Record selected onscreen displays with primary clips (A 189).
Magnification (A 75).
Peaking (A 75).
Description
Description
Recording Video and Photos
Custom Display
2: [Recording Mode]
2: [Interval Counter]
2: [Rec Command]
2: [Frame Rate]
1: [Key Lock]
2: [Time Code]
2: [Remaining Battery]
Custom Display
2: [Output Terminals
Status]
2: [Genlock]
2: [Resolution/
Color Sampling]
2: [Photo]
2: [OSD Output]
2: [OSD Recording]
1: [Magnification]
1: [Peaking]
45