Set The Switch Management Mode - NETGEAR GS750E User Manual

48-Port Gigabit Ethernet Plus Switch with 2 SFP Ports Model GS750E
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5. Select System > Maintenance > Access Control.
6. Select one or more devices.
To select all devices in the table, select the check box in the table heading.
7. Click the Delete button.
The devices are removed from the table and your settings are saved. If you removed
all devices from the table, access control is disabled.

Set the switch management mode

Note: The ProSAFE Plus Utility has reached end-of-life and is no longer supported.
By default, you can manage the switch through a web browser and through the ProSAFE
Plus Utility. You can change the switch management mode so that only management
through the local browser interface is enabled and access through the ProSAFE Plus
Utility is disabled. Even if you disable management through the ProSAFE Plus Utility,
the switch and its IP address on the network are still discoverable through the ProSAFE
Plus Utility.
To set the switch management mode:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the switch using a web
browser on page 7.
The login page displays.
Manage Security 41 User Manual