Ups Power/Alarm Table; Wps; Registration Id; Table 6. Ups Power/Alarm Table - ADTRAN 400 Series Basic Configuration Manual

2.3.4.7

UPS Power/Alarm Table

Table 6
connection.

Table 6. UPS Power/Alarm Table

Pin-Out
1
2
3
4
5
6
7
8
2.3.4.8

WPS

The WPS or "Wi-Fi Protected Setup" function allows you to connect wireless devices without
entering the password in the device. This is enabled by simultaneously pressing the WPS
button on the ONT and the WPS button on the device. To establish a 2.4GHz connection.
press and hold the WPS button for 1 to 2 seconds. For a 5.0GHz connection, press and hold
the WPS button for more than 5 to 10 seconds.
Both the 424RG and 434RG ONT support 2.4 WiFi function. When the WPS button is turned
on (pushed in), the wireless network in your home is secure and encryption is activated.
The WPS button is located on the left-side of the 424RG and on the rear of the 434RG.
2.3.4.9

Registration ID

Registration ID is performed by Serial Number Activation. This occurs when the ONT is
"Discovered" by the OLT.
If AOE Auto Upgrade is active, a new ONT installation will be detected and a fast blinking
FIBER LED will indicate a new software download has commenced. This may take 5 - 10
minutes to complete.
What's Next!
This completes the physical installation of the RG ONT. Proceed to
ration"
61287RGONT-29C
Revision C
indicates which pin is associated with each alarm provided through the UPS
Description
Power Input (+12 VDC)
UPS Status - On Battery
UPS Status - Battery Missing
Signal Return
Power 12 V Return
UPS Status - Replace Battery
UPS Status - Low Battery
No Connection
on page 24 for basic configuration information.
Physical Installation
Alarm
-
1
2
-
-
3
4
-
Section 3, "Basic Configu-
23