Viessmann VITOCROSSAL 200 Service Instructions Manual page 13

Further details regarding the individual steps
Status Service
C
D
Note
Once the gas type has been converted,
the CO values need to be checked for
2
full load and partial load and corrected if
necessary (see page 27 and 28).
R
S
E
F
Commissioning, inspection, maintenance
6. Press button S E to confirm. If
applied successfully, "1" will be
shown briefly in display C under
G
Service, or "0" will appear if it failed.
7. Press button S E to switch to the
operating display.
8. Press button R G.
The system will be restarted.
Note
The setting parameters are displayed
each time the system is restarted.
1 Max. output (70-100 %)
The output setting is not limited.
The base load can also be set (CS
configuration).
2 Gas type (NG = natural gas or LPG
= liquid gas)
3 Installation height (LA or HA)
4 Temperature of temperature lim-
iter
5 Integral for minimum pause time
6 Cycle protection method
(cont.)
13