Viessmann VITOCAL 222-S Installation And Service Instructions Manual page 114

Commissioning/service reports
Control parameters report
Parameters
"Temperature sensor at bottom of DHW
cylinder"
"Enable booster heaters for DHW heat-
ing"
"Enable electric heaters for DHW heat-
ing"
"Priority DHW heating with combi cylin-
der"
"Start attempts for DHW after high pres-
sure shutdown"
Solar
Parameter
"Type solar control unit"
Parameters for solar control module, type
SM1
Electric booster heater
Parameter
"Enable instantaneous heating water
heater"
"Enable electric heaters for DHW heat-
ing"
"Enable instant. heating water heater for
central heating"
"Max. output instantaneous heating wa-
ter heater"
"Output for instant. heating water heater
at power-OFF"
"Dual mode temp instant. heating water
heater"
Internal hydraulics
Parameter
"Heat pump for drying a building"
"Time program for screed drying"
"Flow temperature for external demand"
"Starting time high efficiency circulation
pump"
114
(cont.)
Code Delivered condition Commission-
600E 0
6014 0
6015 1
6016 0
6017 1
Code Delivered condition Commission-
7A00 0
C0xx These parameters will only be displayed if the solar
control module, type SM1, is connected to the heat
pump and "Type solar control unit" is set to "3".
For a description of the parameters, see installation
and service instructions for "solar control module, type
SM1".
Code Delivered condition Commission-
7900 1
7901 0
7902 0
7907 3
790 A 0
790 B 500 (
Code Delivered condition Commission-
7300 0
7303 0
730C 500 (
7365 Do not adjust
ing
ing
ing
≙
50 °C)
ing
≙
50 °C)
Maintenance/
service
Maintenance/
Service
Maintenance/
Service
Maintenance/
Service