Mounting The Bike Handle - Stihl KM 111 R Instruction Manual

English
► Insert the clamp (3) in the loop handle (4) and
position them together on the shaft (5)
► Position clamp (6)
► Position barrier bar (2) – note position!
► Line up the holes
► Insert bolts (7) in the holes – and screw them
into the barrier bar as far as possible
A
8
9
► Fit the loop handle (4) at a distance of (A)
approx. 20 cm (8 in) forward of the control
handle (8)
► Orient the loop handle
► Tighten the bolts – lock the nuts if necessary
The sleeve (9) is present depending on the coun‐
try and must be located between the loop handle
and control handle.
Always leave the barrier bar attached.
6

Mounting the Bike Handle

6.1 Mounting Bike Handle with
Swiveling Handle Support
The machine is supplied with the swiveling han‐
dle support already mounted on the shaft. To
mount the handlebar it is necessary to remove
the clamp moldings.
8
6.1.1
4
► Hold the lower clamp (1) and upper clamp (2)
► Release the wing screw (3) – the clamps are
► Pull out the wing screw – the washer (6)
► Separate the clamp moldings – the
6.1.2
► Place the handlebar (7) in the lower clamp (1)
► Place the upper clamp in position and hold
► Push the wing screw through the two clamps
6 Mounting the Bike Handle
Removing the Clamp Moldings
firmly together.
loose once the wing screw has been released.
They are pushed apart by the two
springs (4 and 5).
remains on the wing screw.
springs (4 and 5) remain in the lower clamp.
Securing the Handlebar
7
so that distance A is no more than 15 cm
(6 in).
both clamp moldings together.
as far as stop – hold all parts together and
secure them.
A
1
0458-436-0121-B