Mounting The Loop Handle - Stihl KM 94 R Instruction Manual

Mounting the Loop Handle

A barrier bar is supplied with the
machine. Fit the barrier bar on the loop
handle.
2
1
Fit the square nuts (1) in the barrier
N
bar (2); the holes must line up.
KM 94 R
4
5
6
1
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Position the clamp (6) against the
N
drive tube.
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) in the holes
N
and screw them into the barrier
bar (2) as far as stop.
Go to "Adjusting and Securing the
N
Loop Handle".
2
3
7
Adjusting and Securing the Loop Handle
A
4
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 22 cm (8.7 in)
Slide the handle to the required
N
position.
Line up the loop handle (4).
N
Tighten down the screws until the
N
loop handle can no longer be
rotated on the drive tube. If no
barrier bar is fitted – lock the nuts if
necessary.
Leave the barrier bar permanently
mounted to the loop handle.
English
11