Table of Contents
Advertisement
SA-AK330GC / SA-AK330GN
Step 12 Squeeze the shaft of lower hook, and then draw it.
Step 13 Rotate the lower spindle in the direction of arrow until
the lower spindle interferes with stopper.
Step 14 Insert the thin tip of minus screwdriver between the
lower spindle and UP/DOWN base, and then slacken the lower
spindle to release the stopper. Then, rotate the lower spindle
and remove it.
Step 15 Rotate the UP/DOWN base at a 90° angle. Then,
All manuals and user guides at all-guides.com
spread the hold bars of loading stopper and remove the
UP/DOWN base.
[Installation for loading stopper ass'y]
Step 1 Align the claw of loading stoppers ass'y with the slot of
spindle base. (Caution should be exercised when alignment of
claw due to the size of claws.)
Step 2 Lower the loading stopper ass'y, and then align the
lower spindle with the trapezoid tooth of relay gear A.
Step 3 Force the loading stopper ass'y, latch the claw firmly.
[Reassembly for mechanism base drive unit]
28
Advertisement
Table of Contents
