Waterfall - Jacuzzi ARGA ARG101C0110 Use & Maintenance

Waterfall

Starting
the function
For the waterfall to work, first
activate the Swirlpool® function
Approximately 10" will pass between
the button being pressed and the
waterfall water being dispensed,
during which the jets and display
will flash blue (this is to signal that
the solenoid valve is in operation)
Stopping
the function
Wait for the tub to be empty before
turning off the main switch. This
ensures the pipes are drained fully.
T
he waterfall is the natural completion of the Swirlpool® function: thanks to the wa-
terfall, you can enhance your hydrotherapy experience with bath salts made especially
for Arga®.

You can pour the bath salts into the specific infuser if desired (please see the relevant
section).

Then activate the Swirlpool® function (if it is not already active, please see the relevant
section).

To activate the waterfall, press the
the finger).
2
1
■ Press the button again (the function is turned off when you lift your finger): the water
flow will reduce gradually and the lights will flash blue, as at the start (to signal that the
solenoid valve is in operation).
The waterfall can also be deactivated by pressing the Swirlpool® function button (this is be-
cause when the pump is switched off, the waterfall solenoid valve is also deactivated).
■ If you do not intend to use the tub again, empty it and switch it off at the main switch.
26
button briefly (the function starts when you lift