Power Saving Mode - Carrier XPower 42TGV CP Series Owner's Manual

7

Power saving mode

The power saving mode saves energy by limiting the maximum current which will effect cooling capacity that the
unit can generate.
Push button during operation.
The air conditioner enters power saving mode.
appears on the display.
Power saving mode will stay in effect until it is cancelled.
To cancel the power saving mode, push
disappears.
To configure the power saving mode settings
4
5
1
Push button for at least four seconds when the air conditioner is not working.
, symbol, and numbers flash.
2
Push (left side of the button) to select an indoor unit to be set.
Each time you push the button, UNIT No. change as follows:
UNIT No.
1-1
The fan of the selected unit runs.
21-EN
1115653821.indd 12
button again.
1
3
2
UNIT No. UNIT No.
1-2 1-3
UNIT No.
1-4
– 11 –
3
Push buttons, to adjust the power saving mode setting.
Each push of the button changes the power level by 1 % within the range from 100 % to 50 %.
The factory default is 75 %.
4
Push button.
5
Push button to complete the setting.
NOTE
During a Power save operation, the maximum current of the outdoor unit is limited. The operating power consumption
might not be lowered, however, under certain conditions.
Capability of the air conditioner is saved during the Power save operation. The room may not become cool or warm
enough.
A Power save operation cannot be programmed with the central control remote controller and depending on the
installation conditions of the outdoor unit.
If multiple units are connected as a group, all of them are put in Power save mode.
The Power save feature might be restricted, depending on the outdoor unit used. For details, contact the original
retailer.
Setting of power level in
power saving mode
15/8/2561 13:32:12
22-EN