Cancel Louver Lock; Power Saving Mode - Carrier RAV-SP180UT-UL Installation Manual

4-way Air Discharge Cassette Type
Louver lock (No swing)
1. Push (right side of the button) for at least
four seconds when the air conditioner is not working.
flashes.
Indicates CODE No. "F1."
2. Select an indoor unit to be set by pushing
(left side of the button).
Each time you push the button, unit numbers
change as follows:
The fan of the selected unit runs and the louvers
start swinging.
UNIT No. UNIT No.
1-1 1-2
UNIT No.
1-4
3. Select a louver you want to lock by pushing TEMP.
buttons.
4. Select the louver direction you do not want to swing
by pushing TIME
(1)
Setting data
0001
(4)
0004
* When (4) or (5) is selected, dew drop may occur
during cooling mode.
5. Determine the setting by pushing
When the setting has been determined,
up.
6. Push button to complete the setting.
0001-0005
(Louver lock position code)
UNIT No.
1-3
buttons.
(2) (3)
0002 0003
(5)
0005
button.
lights

Cancel louver lock

Set the louver direction to "0000" of the louver lock
setup procedure above.
Setting data
• When the setting is canceled,
Other operations are the same as those in
"Louver lock (No swing)".

Power saving mode

1. Push button for at least four seconds when
the air conditioner is not working.
flashes.
Indicates CODE No. "C2."
2. Select an indoor unit to be set by pushing
(left side of the button).
Each time you push the button, unit numbers
change as follows:
UNIT No.
1-1
The fan of the selected unit runs and the louvers
start swinging.
3. Adjust the power save setting by pushing TIME
buttons.
Each push of the button changes the power level by
1% within the range from 100% to 50%.
* The factory default is 75%.
4. Determine the setting by pushing
5. Push button to complete the setting.
– 26 –
Installation Manual
0000
goes out.
UNIT No. UNIT No.
1-2 1-3
UNIT No.
1-4
Setting of power level in
power saving mode
button.
EN
26-EN