Step 12 Connect Drain Line; Drain Line Installation - Frigidaire FMB330RG Installation Instructions Manual

STEP 12 CONNECT DRAIN LINE

FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8", 3/4" or 1" diameter
connections on the air gap, waste tee or disposer. Cut on the
marked line as required for your installation.
Cutting Lines
3/4"
1"
IMPORTANT: Do not cut corrugated
portion of hose
• If a longer drain hose is required, add up to 42" of length for
a total of 10 ft. to the factory installed hose. Use 5/8" or 7/
8" inside diameter hose and a coupler to connect the two
hose ends. Secure the connection with hose clamps.
Hose Clamp
• Secure the drain hose to the air gap, waste tee or disposer
with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
Installation Instructions
5/8"
Figure U
Hose Clamp
Coupler
Figure V

DRAIN LINE INSTALLATION

• Connect drain line to air gap, waste tee or disposer using
either previously determined method.
Method 1 – Air gap with waste tee or disposer
Waste Tee Installation
Method 2 – High drain loop with waste tee or
disposer
Fasten to underside
of countertop
32"
Min.
18"
Min.
Waste Tee Installation
IMPORTANT
When connecting drain line to disposer,
check to be sure that drain plug has been
removed. DISHWASHER WILL NOT DRAIN
IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching dishwasher
drain hose to the disposer.
1 0
Disposer Installation
Figure W
Fasten to underside
of countertop
18"
Min.
Disposer Installation
Figure X
–
Remove
Disposer
Plug