Step 12 Connect Drain Line; Drain Line Installation - Frigidaire FFBD1821M Installation Instructions Manual

STEP 12 CONNECT DRAIN LINE

FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8", 3/4" or 1"
diameter connections on the air gap, waste tee or
disposer. Cut on the marked line as
installation.
Cutting Lines
3/4"
1"
IMPORTANT: Do not cut corrugated
portion of hose
• If a longer drain hose is required, add up to 42" of
length for a total of 10 ft. to the factory installed
hose. Use 5/8" or 7/8" inside
coupler to connect the two hose ends. Secure the
connection with hose clamps.
Hose Clamp
• Secure the drain hose to the air gap, waste tee or
disposer with clamps.
NOTE:
TOTAL DRAIN HOSE LENGTH MUST NOT
EXCEED 10 FEET FOR PROPER DRAIN OPERATION.
Installation Instructions
required for your
Figure U
5/8"
diameter hose and a
Hose Clamp
Coupler
Figure V

DRAIN LINE INSTALLATION

• Connect drain line to air gap, waste tee or disposer
using either previously determined method.
Method 1 – Air gap with waste tee or disposer
Waste Tee Installation
Method 2 – High drain loop with waste tee or dis-
poser
Fasten to underside
of countertop
32"
Min.
18"
Min.
Waste Tee Installation
IMPORTANT
When connecting drain line to
disposer, check to be sure that drain
plug has been removed.
DISHWASHER WILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always be
sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer.
10
Disposer Installation
Figure W
Fasten to underside
of countertop
18"
Min.
Disposer Installation
Figure X
–
Remove
Disposer
Plug