Fans - HP 16-b0 Series Maintenance And Service Manual

apply thermal gel are noted by small square brackets in white on the board. (3) Reinstall the
thermal module onto the system board.
Reverse this procedure to install the heat sink.

Fans

To remove the fans, use this procedure and illustration.
Table 5-8 Fans description and part number
Description
Fan, 80 W
Fan, 60 W
Before removing the fans, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drives (see
5. Remove the heat sink (see
Remove the fans:
1. Remove the two Phillips M2.0 × 5.0 screws (1) from the right fan and three Phillips M2.0 × 5.0 screws (1)
from the left fan.
2. Disconnect the fan cables from the system board (2).
3. Remove the fans from the computer (3).
Reverse this procedure to install the fans.
Preparation for disassembly on page
Bottom cover on page
Battery on page 32).
Solid-state drive on page
Heat sink on page 39).
31).
34).
Component replacement procedures
Spare part number
M57161-001
M57160-001
31).
41