HP 16-b0 Series Maintenance And Service Manual page 62

NOTE: The display assembly is available as a spare part only at the subcomponent level. For display
assembly spare part information, see the individual removal subsections.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drives (see
5. Remove the power connector cable (see
6. Remove the heat sink (see
7. Remove the fans (see
8. Remove the system board (see
Remove the display assembly:
1. Remove the antenna cable from the computer by releasing the tape (1), and then removing the
antennas cable from the computer (2).
2. Remove the six Phillips M2.5 × 3.5 screws (1) that secure the display assembly to the computer.
3. Open the display to about 45° (2), and the close the display (3). This opens the hinges.
54 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 32).
Solid-state drive on page
Power connector cable on page
Heat sink on page 39).
Fans on page 41).
System board on page
31).
34).
38).
45).
31).