To Install The Outdoor Unit; To Provide Drainage; To Install The Discharge Grille - Daikin Altherma 3 M Installation Manual

4.2.2

To install the outdoor unit

1 Put the slings (delivered as accessories) through the unit's feet
(left and right).
2 Carry the unit by the slings, and put it onto the installation
structure.
±150
kg
3 Remove the slings, and dispose of them.
4 Fix the unit to the installation structure.
4.2.3

To provide drainage

INFORMATION
If necessary, you can use a drain pan (field supply) to
prevent drain water from dripping.
NOTICE
If the unit CANNOT be installed fully level, always make
sure that the inclination is towards the backside of the unit.
This is required to guarantee proper drainage.
EBLA09~16DA + EDLA09~16DA
Daikin Altherma 3 M
4P620239-1 – 2020.06
6× M12
NOTICE
If drain holes of the outdoor unit are covered by a mounting
base or by floor surface, raise the unit to provide a free
space of more than 150 mm under the outdoor unit.
Drain holes (dimensions in mm)
A
171 758
B
43
48
107
288
451
613
776
A Discharge side
B Distance between anchor points
C Bottom frame
D Knockout hole for snow
E Drain hole for safety valve
F Drain holes
Snow
In regions with snowfall, snow might build up and freeze between the
heat exchanger and the casing of the unit. This might decrease the
operating efficiency. To prevent this:
1 Remove the knockout hole (a) by tapping on the attachment
points with a flat head screwdriver and a hammer.
a
2 Remove the burrs, and paint the edges and areas around the
edges using repair paint to prevent rusting.
NOTICE
When making knockout holes, do NOT damage the casing
and underlying piping.
4.2.4

To install the discharge grille

1 Insert the hooks. To prevent breaking the hooks:
▪ First insert the bottom hooks (2×).
▪ Then insert the top hooks (2×).
2 Insert and fix the screws (4×)(delivered as accessory).
4 Unit installation
300 148
B
C E
D F
=
Installation manual
9