Validation And Liability; Limitations On Liability; General Safety Warning - Omron TM Series Hardware Installation Manual

Results of the risk assessment may require the use of additional risk reduction measures.

Power to the robot and its power supply must be locked out and tagged out or have means to control

hazardous energy or implement energy isolation before any maintenance is performed.
Dispose of the product in accordance with the relevant rules and regulations of the country or area

where the product is used.

2.4 Validation and Liability

The information contained herein neither includes how to design, install, and operate a complete robotic arm
system, nor involves the peripherals that may affect the safety of the complete system. The integrators of the robot
should understand the safety laws and regulations in their countries and prevent hazards from occurring in the
complete system.
This includes but is not limited to:
Risk assessment of the whole system

Adding other machines and additional risk reduction measures based on the results of the risk assessment

Using appropriate software safety features

Ensuring Users will not modify any safety measures

Ensuring all systems are correctly designed and installed

Clearly labeling user instructions

Clearly marking the contact information for the integrator

Making relevant documents accessible, including the risk assessment, and this manual

CAUTION:
This product is a partly complete machine. The design and installation of the complete system
must comply with the safety standards and regulations in the country of use. Users and
integrators of the robot should understand the safety laws and regulations in their countries
and prevent major hazards from occurring in the complete system.

2.5 Limitations on Liability

Even if the safety instructions are followed, any safety information in the manual shall not be considered as a
guarantee that the product will not cause any personal injury or property damage.

2.6 General Safety Warning

1.
The noise measured in a factory setting is about 49.3 dB (A) without production. (Measured 1m from the robot
and 1.6m above the floor, at 80% of maximum speed). If the sound pressure is over 80 dB(A) while operating,
wear proper ear protection.
2.
Environmental Conditions:
Medium & Heavy Payload Series-Hardware Installation Manual TM12/14 Series Hardware Version: 3.2
12