Safety Safety Alert Symbol This Safety Alert Symbol (Figure 2) is used both in this setup instructions and on the machine to identify important safety messages which must be followed to avoid accidents This symbol means: ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Figure 3 Figure 2 1.
Page 5
Installing the Hood and Bags Note: If your mower does not have mounting holes on the foot rest, position the back of the weight support assembly on the cross bar under the foot WARNING rest. Center the weight support assembly and mark the two mounting holes on the lip of the foot rest.
Page 6
Adjusting the Hood Hinge If the hood does not stay open with the upper tube installed, tighten the pivot hardware until it does. Installing the Discharge Baffle—42 and 52 Inch Decks Only 1. Remove fasteners in the deck as shown in Figure 9. Retain for reuse if the discharge baffle is removed.
Page 7
Always install the original Exmark blades, washers and blade bolts as shown. For Mower Serial Numbers 719,999 and Figure 11 Lower 1.