Palm-Rest And Keyboard Assembly; Removing The Palm-Rest And Keyboard Assembly - Dell Inspiron 5300 Service Manual

2. Connect the right speaker cable and left speaker cable to the respective connectors on the system board.
3. Connect the coin-cell battery cable to the connector on the system board.
4. Connect the fingerprint-reader cable, I/O-board cable, touchpad cable, keyboard cable and keyboard-backlit cable to the respective
connectors and close the latch to secure the cables to the connectors on the system board.
Next steps
1. Install the display assembly.
2. Install the solid state drive.
3. Install the heat sink.
4. Install the fan.
5. Install the base cover.
6. Follow the procedure in

Palm-rest and keyboard assembly

Removing the palm-rest and keyboard assembly

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the 4-cell battery.
4. Remove the 3-cell battery.
5. Remove the wireless card.
6. Remove the speakers.
7. Remove the system board.
NOTE: The system board can be removed with the heat sink attached.
8. Remove the display assembly.
9. Remove the power-adapter
10. Remove the touchpad.
About this task
The following image indicates the palm-rest and keyboard assembly and provides a visual representation of the removal procedure.
42 Removing and installing components
After working inside your computer.
Before working inside your
port.
computer.