Installing the I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of I/O board and provides a visual representation of the installation procedure.
Steps
1. Align and place the I/O board on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
3. Connect the I/O-board cable and close the latch to secure the cable to the I/O board.
4. Adhere the tape that secures the I/O-board cable to the fan.
5. Adhere the tape that secures the I/O-board cable to the I/O board.
Next steps
1. Install the fan.
2. Install the
3-cell
battery.
3. Install the
4-cell
battery.
4. Install the
base
cover.
5. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
39