Table of Contents
Advertisement
2. Turn the output shaft to align one of the holes in the
drive disc with the related hole in the gear housing.
3. Put the locking pin (C) in the hole to lock the shaft.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To connect the battery to the product
WARNING: Only use Husqvarna original
batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click.
CAUTION: If the battery does not move
easily into the battery holder, the battery
is not installed correctly. This can cause
damage to the product.
3. Make sure that the battery is installed correctly.
Work position
•
Hold the product with 2 hands.
•
Hold the product on the right side of your body.
•
Keep the cutting attachment below waist level.
•
Keep body parts away from the hot surfaces.
•
Keep body parts away from the cutting attachment.
12
4. Turn the trimmer head (A) counterclockwise to
attach.
A
Operation
Before you operate the product
•
Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
•
Do an overhaul inspection of the product.
•
Do the safety inspections, maintenance and
servicing that are given in this manual.
•
Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
•
Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they have been
hit or if they have cracks.
B
C
785 - 001 - 04.12.2019
Advertisement
Table of Contents
