Table of Contents
Advertisement
CAUTION:
shaft (C) engages with the gear in the
cutting unit.
3. Tighten the screw (A) with your fingers. Make sure
that screw (A) goes into the hole in the shaft.
Introduction
WARNING:
safety chapter before you use the product.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note:
The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To charge the battery
Note:
Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger.
2129 - 002 - 24.11.2023
Make sure that the drive
Operation
Read and understand the
4. Tighten the screw (A) fully.
5. Tighten the screw (B) fully.
3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
4. When all LEDs on the battery come on, the battery is
fully charged.
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
Only use Husqvarna
11
Advertisement
Table of Contents
