Filter Control; Table 7-3 Filter Settings - Henny Penny KFC Velocity Series PXE-100 Operation Manual

Menu Display Name
SP-23 CLEAN-OUT TEMP
SP-24 CLEAN-OUT
MINUTES
7 7 . . 6 6 F F i i l l t t e e r r C C o o n n t t r r o o l l
Watch a video explaining important steps in the filter control
T T R R A A I I N N I I N N G G :
menu.
The Filter Control mode allows the parameters during a filter cycle to be modified for
the best results depending on the oil type. Each parameter is grouped into a section
that controls a particular settings. See
the Filter Control menu do the following:
Press and hold the menu button until *MAIN* displays.
1 1 ) )
Press the menu button again. The 4. PROG menu displays.
2 2 ) )
Select 4 4 . . P P R R O O G G .
3 3 ) )
Type 1 1 2 2 3 3 . The 6. FLTR CTRL menu displays.
4 4 ) )
Select 6 6 . . F F L L T T R R C C T T R R L L .
5 5 ) )
Use the left or right arrow to navigate through the options.
6 6 ) )
Program Display
Code
I I N N F F O O :
• If Heated mode is selected in the SP-22 menu,
operators may select a temperature between 40°F
– 195°F with which to heat the water. Higher
temperatures require Personal Protective
Equipment (PPE) to prevent burns.
• If Cold-Soak mode is selected in the SP-22 menu,
this setting displays Cold-Soak and can not be
changed.
• If Heated mode is selected in the SP-22 menu,
operators may select a time 1 Min. to 99 Min. The
timer starts after the water is heated to the
temperature selected in SP-23. The clean cycle
time allows the amount of time necessary to scrub
the vat and lid before prompting to drain and rinse.
• If Cold-Soak mode is selected in the SP-22 menu,
this setting displays Cold-Soak and can not be
changed.
Table 7-3 Filter Settings , page
T T a a b b l l e e 7 7 - - 3 3 F F i i l l t t e e r r S S e e t t t t i i n n g g s s
Q Q u u i i c c k k F F i i l l t t e e r r S S e e t t t t i i n n g g s s
Function
73. To access
Description
73