Fostex CR200 Service Manual page 64

CR200
5.3 DISASSEMBLING
(1) REMOVE THE TRAY PANEL
Hold the tray panel with your hands as shown in Fig. 1, and
grasp the tray with your thumbs and then lift the tray panel
up while pulling it toward you with the other fingers. (Fig. 2)
Tray panel
Pull
(2) INSTALL THE TRAY PANEL
Align the tray panel with the grooves located at both edges
of the tray. And then press it down till it stops. (Fig. 3)
Tray panel
64
Fig. 1
Fig. 2
Tray
Fig. 3
(3) REMOVE AND SET UP THE HEAD BOARD ASSY
1. Remove the rack mount angle L, R and bonnet.
Remove the tray panel (Refer to section 1).
2.
Remove the five screws of the front panel and remove a
3.
screw of HEADPHONE BOARD ASSY.
4.
Remove the under panel to sliding it towards the right.
Front panel
1
Rack mount
angle L
Under panel
5. Pull out the right side of the front panel to the front and
remove the four screws of the board.
HEAD BOARD
ASSY
Front panel
6. Remove the fixtures of the wires connected to the board
(cord holder, PCB binder).
7. Place the HEAD BOARD ASSY upright against the slit
of the float base.
Slit
Cord holder
Loosen
(Unfasten the
fixed wire rod)
Float base
1
3
3
4
Rack mount
4
angle R
3
Fig. 4
Screw
Fig. 5
HEAD BOARD
ASSY
Servo mechanism
assy TT
Fig. 6
(Right side)
HEADPHONE
BOARD ASSY
3 3
Slit