How To Register A Tcu On The System Network - Siemens SINUMERIK 840D sl Manual

Networking
5.4 Service and diagnostics
Assigning a name
If, as described above, the system automatically follows the "New" path, an additional message
will appear: "This operator panel (TCU) must be new, because there are no inactive panels."
This message will not appear if "New" is selected manually.
Figure 5-13
An available TCU name is suggested in the input field, although the user is able to change this.
The default name is "TCU<N>", where <N> is the lowest number yet to be used. If, however,
the name is already allocated after the OK softkey has been pressed, which may happen if a
number of TCUs log on at the same time, and the suggestion has not changed, a new and
unused name will be specified.
If the name selected was still available, this will now be allocated, and the TCU settings can still
be adapted if required. To enable any changes to be made, a new dialog appears in which all
the parameters have been pre-assigned their default values. You can make any changes you
like or just select "OK" to accept the existing values.
5.4.6

How to register a TCU on the system network

Requirement
The boot server (NCU or PCU 50/IPC) defined in the system network as a DHCP master must
be switched on and available in the network.
68
TCU menu: Name of TCU
Operator panel front: OP 012
Manual, 05/2019, A5E36371591B AB