Siemens SINUMERIK 840D sl Manual page 58

Networking
5.4 Service and diagnostics
Figure 5-5
Central area with the server list:
The individual server lines contain either "Show WHAT on NAME (IP)" or the IP address only
where the name is unknown.
Session number
Session 0
Session 4
Session 5
Session 6
...
Session <N>
These details are followed by a status message regarding the accessibility of the VNC server.
● "Connection not ok" appears if it is already impossible to access the server from the IP side
(if switched off, for example).
● "HMI running/ not running", if an HMI VNC server is accessible.
The VSK8, Return or right cursor keys can be used to launch a VNC viewer for the selected
server.
Connection status:
Further details on the connection status can be called with the "Details" softkey. In the next
dialog, "not ok" or "not running" are accompanied by an additional error message with more
58
TCU menu: Active sessions
VNC server
HMI
Command shell
System logfile
System Network Center (SNC)
Other servers
Manual, 05/2019, A5E36371591B AB
Operator panel front: OP 012