Siemens SIMOTICS FD 1MQ1 Operating And Installation Instructions page 110

Operation
8.1 Safety instructions for operation
Faults in operation
Any changes with respect to the normal condition can indicate that the machine is not
functioning correctly.
● Higher power consumption, temperatures or vibration levels.
● Unusual noise or smells.
● Monitoring devices respond.
These changes can cause faults which can result in eventual or immediate death, serious injury
or material damage.
● Immediately inform the service personnel.
● If you are in doubt, immediately switch off the machine, carefully observing the system-
Damage caused by condensation
Humidity in the air can condense for intermittent duty or load fluctuations. Condensate can
collect. Moisture can have a negative impact on the winding insulation or result in damage, such
as corrosion.
● Ensure that any condensation can freely flow away.
Risk of burn injuries as a result of hot surfaces
Individual machine parts can become hot in operation. Burns can result when coming into
contact with these parts.
● Never touch machine parts during operation.
● Allow the machine to cool down before starting work.
● Check the temperature of parts before touching them. If required, wear suitable protective
Excessively high machine temperature when heating is switched on
If the anti-condensation heating is operated while the machine is running, this can increase the
temperatures inside the machine. Material damage can result.
● Make sure that the anti-condensation heating is switched off before the machine is switched
● Only operate anti-condensation heating when the machine is switched off.
Explosion hazard if the bridging is removed from the insulated bearing
Removing the factory-fitted bridging of the insulated bearing leads to potential differences
between the rotor and the grounded motor. This can cause the generation of sparks, which
110
specific safety conditions.
equipment.
on.
SIMOTICS FD 1MQ1
Operating Instructions 01/2019