Fitting Instructions; Removal Instructions - 3M 8210Plus User Instructions

8210Plus/8210PlusMX/8210/8210MX/07048/8110S
7. Individuals with a compromised respiratory system, such as asthma or emphysema, should consult a physician and must complete a medical
evaluation prior to use.
8. When stored in accordance with temperature and humidity conditions specified below, the product may be used until the "use by" date specified
on the packaging.
Storage Conditions and Shelf Life
Before use, store respirators in the original packaging away from contaminated areas, dust, sunlight, extreme temperatures, excessive moisture
and damaging chemicals. When stored in accordance with temperature and humidity conditions specified below, the product may be used until the
"use by" date specified on packaging. Always inspect product and conduct a user seal check before use as specified in the User Instructions. If you
cannot achieve a proper seal, do not use the respirator.
+86˚F
+30˚C
End of Shelf Life
Use respirators before the "use by" date specified on packaging
<80%
+86˚F
Storage Temperature Range
+30˚C
-20°C (-4°F) to +30°C (+86°F).
-4˚F
<80%
-20˚C
+86˚F
Storage Maximum Relative Humidity
+30˚C
<80% RH
-4˚F
-20˚C <80%
Time Use Limitation
If respirator becomes damaged, soiled or breathing becomes difficult, leave the contaminated area immediately and replace the respirator.

Fitting Instructions

Must be followed each time respirator is worn.
1. Prestretch top and bottom straps before placing respirator on the face (8210/8210MX only) (Fig. 1).
2. Cup the respirator in your hand, with the nosepiece at your fingertips, allowing the headbands to hang freely below your hand (Fig. 2).
3. Position the respirator under your chin with the nosepiece up. Pull the top strap over your head resting it high at the top back of your head. Pull the
bottom strap over your head and position it around the neck below the ears (Fig. 3).
4. Place your fingertips from both hands at the top of the metal nosepiece. Using two hands, mold the nose area to the shape of your nose by pushing
inward while moving your fingertips down both sides of the nosepiece (Fig. 4).
W Pinching the nosepiece using one hand may result in improper fit and less effective respirator performance. Use two hands.
5. Perform a User Seal Check prior to each wearing. To check the respirator-to-face seal, place both hands completely over the respirator and exhale
sharply. Be careful not to disturb the position of the respirator. If air leaks around nose, readjust the nosepiece as described in step 4. If air leaks
at the respirator edges, work the straps back along the sides of your head (Fig. 5). If you CANNOT achieve a proper seal, DO NOT enter the
contaminated area. See your supervisor.
Fig. 1

Removal Instructions

See step 3 of Fitting Instructions and cup respirator in hand to maintain position on face. Pull bottom strap over head. Still holding respirator in
position, pull top strap over head and remove respirator.
This respirator contains no components made from natural rubber latex.
Fig. 2 Fig. 3
2
(English)
Fig. 4 Fig. 5