Sony SLV-N99 Operating Instructions Manual page 11

010GET.fm Page 11 Friday, November 30, 2001 1:47 PM
C Use this hookup if your TV has the Control S function
VCR
AUDIO VIDEO
LINE-1
CONTROL S
IN
IN
LINE
OUT
Control S cable (not supplied)
Notes
• To play a tape in stereo, you must use the A/V connection.
• Use the RK-G69 Control S cable (not supplied) for Control S connections.
Completing A/V hookup:
After you've connected your TV and completed antenna or cable hookup, return to
this procedure to complete VCR set up. This will prevent unwanted noise in the RF
channel.
Press MENU and select
ADVANCED OPTIONS.
TIMER SET/CHECK
SETTINGS
ADVANCED OPTIONS
SELECT :
SET : OK
QUIT : MENU
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of the TV
receiver should be made only as shown in the following instructions. Failure to do so may result
in operation that violates the regulations of the Federal Communications Commission regarding
the use and operation of RF devices. Never connect the output of the VCR to an antenna or
make simultaneous (parallel) antenna and VCR connections at the antenna terminals of your
receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820- 40 of the
NEC that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable
entry as practical.
TV
IN
VIDEO
AUDIO OUT
AUDIO
CONTROL S OUT
Audio/video cable
(not supplied)
Audio cable (not supplied)
Set AUTO ANT SELECT
to OFF and press OK.
ADVANCED OPTIONS
AUTO ANT SELECT
AUTO STEREO
TUNER AUDIO
TAPE SELECT
,
AUTO TAPE SPEED
FAVORITE CH
NEXT
RETURN
SELECT :
SET : OK
QUIT : MENU
For details, see page 88.
filename[010GET.fm] model name1[SLV-N99]
Stereo receiver
AUX IN
PAGE 1
ON
OFF
AUTO
ON
ON
11
Hookups
[3-071-065-11(1)]