Dhcp Server Settings - Fortinet FortiGate FortiGate-200A Administration Manual

Server

DHCP server settings

76
Figure 23: Server options
Name
Interface
Domain
Default Gateway
IP Range
Network Mask
Lease Time
DNS Server
WINS Server
Option
To configure a DHCP server for an interface
After configuring an interface to be a DHCP server (using the procedure
an interface to be a DHCP server" on page
the interface.
1 Go to System > DHCP > Server.
2 Select Create New.
Enter a name for the DHCP server configuration.
Select the interface for which to configure the DHCP server.
Enter the domain that the DHCP server assigns to DHCP clients.
Enter the IP address of the default gateway that the DHCP server
assigns to DHCP clients.
Enter the starting IP and ending IP for the range of IP addresses that this
DHCP server assigns to DHCP clients.
Enter the netmask that the DHCP server assigns to DHCP clients.
Select Unlimited for an unlimited lease time or enter the interval in days,
hours, and minutes after which a DHCP client must ask the DHCP server
for new settings. The lease time can range from 5 minutes to 100 days.
Enter the IP addresses of up to 3 DNS servers that the DHCP server
assigns to DHCP clients.
Add the IP addresses of one or two WINS servers that the DHCP server
assigns to DHCP clients.
Up to three custom DHCP options that can be sent by the DHCP server.
Code is the DHCP option code in the range 1 to 255. Option is an even
number of hexadecimal characters and is not required for some option
codes. For detailed information about DHCP options, see RFC 2132,
DHCP Options and BOOTP Vendor Extensions.
01-28006-0072-20041105
75), you must configure a DHCP server for
System DHCP
"To configure
Fortinet Inc.