Concentrator; Concentrator List - Fortinet FortiGate FortiGate-200A Administration Manual

VPN

Concentrator

Concentrator list

FortiGate-200A Administration Guide
Encryption Key Enter the Encryption Key.
Each two character combination entered in hexadecimal format represents
one byte. Depending on the encryption algorithm you have selected, you may
be required to enter the key in multiple segments. Use the same encryption
key at both ends of the tunnel.
•
•
•
•
•
Authentication Select an Authentication Algorithm from the list.
Algorithm Use the same algorithm at both ends of the tunnel.
Authentication Enter the Authentication Key. Each two character combination entered in
hexadecimal format represents one byte. Use the same authentication key at
Key
both ends of the tunnel.
•
•
Concentrator Select a concentrator if you want the tunnel to be part of a hub and spoke
VPN configuration. See
NAT/Route mode only.
Configure IPSec VPN concentrators to create hub and spoke configurations. IPSec
VPN concentrators are only available in NAT/Route mode.
To configure a concentrator
1 Go to VPN > IPSEC > Concentrator and add a concentrator.
2 Add the required Phase 2 configurations to the concentrator.
Figure 128:IPSec VPN concentrator list
Create New
Concentrator Name The names of the IPSec VPN concentrators that have been added.
For DES, enter a 16 character (8 byte) hexadecimal number (0-9, A-F).
For 3DEs, enter a 48 character (24 byte) hexadecimal number (0-9, A-F).
Separate the number into three segments of 16 characters.
For AES128, enter a 32 character (16 byte) hexadecimal number
(0-9, A-F). Separate the number into two segments of 16 characters.
For AES192, enter a 48 character (24 byte) hexadecimal number
(0-9, A-F). Separate the number into three segments of 16 characters.
For AES256, enter a 64 character (32 byte) hexadecimal number
(0-9, A-F). Separate the number into four segments of 16 characters.
For MD5, enter a 32 character (16 byte) hexadecimal number (0-9, A-F).
Separate the number into two segments of 16 characters.
For SHA1, enter a 40 character (20 byte) hexadecimal number (0-9, A-F).
Separate the number into two segments, the first of 16 characters and the
second of 24 characters.
"Redundant IPSec VPNs" on page
Select Create New to add an IPSec VPN concentrator.
01-28006-0072-20041105
Concentrator
289. Available in
257