Fortinet FortiGate FortiGate-200A Administration Manual page 100

SNMP
100
Figure 34: SNMP community options (part 1)
Figure 35: SNMP community options (part 2)
Community Name Enter a name to identify the SNMP community.
Hosts Identify the SNMP managers that can use the settings in this SNMP
community to monitor the FortiGate unit.
IP Address The IP address of an SNMP manager than can use the settings in this
SNMP community to monitor the FortiGate unit. You can also set the IP
address to 0.0.0.0 to so that any SNMP manager can use this SNMP
community.
Interface Optionally select the name of the interface that this SNMP manager uses
to connect to the FortiGate unit. You only have to select the interface if
the SNMP manager is not on the same subnet as the FortiGate unit. This
can occur if the SNMP manager is on the Internet or behind a router.
Add Select Add to add more SNMP managers. You can add up to 8 SNMP
managers to a single community. Select the Delete icon to remove an
SNMP manager.
01-28006-0072-20041105
System config
Fortinet Inc.