Troubleshooting - Yamaha Ego Avantiz Owner's Manual

Periodic maintenance and adjustment
5. Insert a new bulb into the socket
by pushing it in and turn it clock-
wise until it stops.
NOTICE
If a taillight bulb of different wattage
than recommended is used, it may
cause the battery to discharge or af-
fect the taillight lighting.
6. Install the bulb socket (together
with the bulb) by turning it clock-
wise.
7. Install the panel, and then close
the seat.
7
Rear turn signal light bulb
1. Open the seat. (See page 4-9.)
2. Remove panel C. (See page 7-8)
3. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise.
ECAU0091
1. Rear turn signal light bulb
4. Remove the burnt-out bulb from
the socket by pulling it out.
5. Insert a new bulb into the socket.
NOTICE
If a turn signal light bulb of different
wattage than recommended is used,
the turn signal light flashing may be
affected.
6. Install the bulb socket (together
with the bulb) by turning it clock-
wise.
7. Install the panel, and then close
the seat.
7-29

Troubleshooting

Although Yamaha scooters receive a
thorough inspection before shipment
from the factory, trouble may occur
during operation. Any problem in the
fuel, compression, or ignition systems,
1
for example, can cause poor starting
and loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems your-
self. However, should your scooter re-
quire any repair, take it to a Yamaha
dealer, whose skilled technicians have
ECAU0081
the necessary tools, experience, and
know-how to service the scooter prop-
erly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
When checking the fuel system, do
not smoke, and make sure there are
no open flames or sparks in the ar-
ea, including pilot lights from water
WARNING
EAU25862
EWA15142