Draytek Vigor2765 Series Quick Start Manual page 15

Note If the WAN 1 IP address displayed begins with 172.16.x.x, it's
possible that the ISP has not accepted the supplied Username
and Password for the Internet connection.
Check that the ISP Access Setup - Username and Password match
the details supplied by your ISP.
4 . 2 . 2 D H C P /
4 . 2 . 2 D H C P /
1. Go to [WAN] > [General Setup] and click on the WAN1 link:
2. On the settings page:
Set the Enable option to Yes to activate the WAN1 connection

Set the Active Mode to Always On

Enable the Service – VLAN Tag insertion

Set the Tag value setting to 101

DSL mode can be set to "VDSL2 only" but this is not required

Note The VLAN tag value of 101 is required to connect to ISPs that
operate on the Openreach VDSL2 network, if your ISP operates on
a different VDSL2 network, this tag value may differ.
Please check with your ISP or the DrayTek UK Knowledgebase for
ISP specific guides.
S t a t i c I P c o n
S t a t i c I P c o n
n e c t i o n w i t h
n e c t i o n w i t h
11
F T T C V D S L 2
F T T C V D S L 2