Restoring The Previous Configuration - Fortinet FortiController FortiController-5208 System Manual

Fortinet forticontroller forticontroller-5208: user guide
Hide thumbs Also See for FortiController FortiController-5208:
Table of Contents

Advertisement

Installing firmware images from a system reboot using the CLI

Restoring the previous configuration

22
8
Type I and the Configuration and information menu is displayed:
[S]:
Set serial port baudrate(will take effect on next
boot).
[T]:
Set image download port.
[C]:
Set DHCP enable (will take effect on next boot).
[D]:
Set bootup debug message display (will take effect
on next boot).
[I]:
Display hardware information.
[Q]:
Quit this menu.
[H]:
Display this list of options.
Enter S,T,C,D,I,Q,or H:
9
Type T to set the image download port. The following message will appear:
Enter image download port number [1]:
10
Enter the port number used to connect to the network shared with the TFTP
server and press Enter.
11
Type Q to return to the boot menu.
12
Type G to get to the new firmware image form the TFTP server.
The following message appears:
Enter TFTP server address [192.168.1.168]:
13
Type the address of the TFTP server and press Enter:
The following message appears:
Enter Local Address [192.168.1.188]:
14
Type an IP address the FortiController-5208 module can use to connect to the
TFTP server. The IP address can be any IP address that is valid for the network
the interface is connected to. Make sure you do not enter the IP address of
another device on this network.
The following message appears:
Enter File Name [image.out]:
15
Enter the firmware image filename and press Enter.
The TFTP server uploads the firmware image file to the FortiController-5208
module and messages similar to the following are displayed:
Save as Default firmware/Backup firmware/Run image without
saving: [D/B/R]
16
Type D.
The FortiController-5208 module installs the new firmware image and restarts.
The installation might take a few minutes to complete.
Change the internal interface address, if required. You can do this from the CLI
using the following command:
FortiController-5208 Firmware
FortiController-5208 System Guide
01-30000-0376-20070615

Advertisement

Table of Contents
loading

Table of Contents