Table of Contents
Advertisement
Installing the Starter Kit configuration
Obtaining and installing the FortiAP firmware
Installing the Starter Kit configuration
Obtaining the configuration file
10
To install the firmware on the FortiGate unit
1 Log in to the FortiGate unit with user name "Admin" and password "fortinet".
See
"To verify the FortiGate unit firmware" on page 9
for more information.
2 Go to System > Maintenance > Firmware and select Upgrade.
3 Select Browse, find the firmware that you downloaded and then select OK.
The configuration of the Starter Kit is based on FortiAP firmware version 112. If this is not
the installed version on the FortiAP units, you need to download and install build 112.
To get FortiAP firmware
1 Log on to the Support website at https://support.fortinet.com/.
2 Go to Download > Firmware Images.
3 Select FortiAP > v4.00 > 4.0MR2 > MR2_Patch_2.
4 Download the file that corresponds to your model.
The Starter Kit contains FortiAP-220A units, FAP_22A_v4.2.0_b0112 is the correct file.
5 Copy the file to a TFTP server accessible from your FortiGate unit.
To install the firmware on the FortiAP units
1 Log in to the FortiGate unit with user name "Admin" and password "fortinet".
See
"To verify the FortiGate unit firmware" on page 9
for more information.
2 Go to System > Dashboard > Status and enter the following command in the
CLI Console: (substitute your TFTP server IP address for x.x.x.x)
execute wireless-controller upload-wtp-image tftp
FAP_22A_v4.2.0_b0112 x.x.x.x
3 After the upload completes, go to Wireless Controller > Configuration > Access Points,
select the FortiAP units and then select Reset All.
4 After the reset completes, check that the Version column shows build 112.
The Starter Kit includes a configuration file which simplifies entering the correct
configuration settings into your FortiGate unit.
The Customer Support site has a configuration file for a FortiGate-80CM with two FortiAP-
220A units. The configuration file can be modified for other FortiGate models.
To download a configuration file
1 Log on to the Support web site at https://support.fortinet.com/.
2 Go to Download > Firmware Images.
3 Select FortiAP > StarterKit.
4 Download StarterKit/Starter_Kit_FG-80CM_4.0MR2Patch1_20100916.zip.
5 Expand the .zip file to obtain the configuration file FG-80-Starter_Kit_20100907.conf.
FortiAP™ Wireless Starter Kit
or see the unit's QuickStart Guide
or see the unit's QuickStart Guide
Wireless Starter Kit Guide for FortiOS 4.0 MR2
01-420-139115-20110223
http://docs.fortinet.com/
•
Feedback
Advertisement
Table of Contents
