Stanley STST1825-AR Instruction Manual page 21

Installing the extension table and extension rail
Insert the extension pieces into the holes of the table (See
Fig. H1) and screw down the knob. (See Fig. H2)
Insert the extension rails into the holes of the table (See
Fig. H3)
Assemble the handle (See Fig. H4)
Put the handle on the extension table and tighten it with
supplied screws.
G2
Assembly of the table saw
Elevating and lowering handle
1. Mount the blade elevation handle (8) on the wheel by
H1
Mounting the rip fence
2. Mount the locking handle onto the front of the rip fence
3. If needed, release the locking handle by pulling it
H2
Front locking
plate
Locking
H3
handle
tightening the nut in the handle. (See Fig. I)
(1) by tightening the nut in the handle. (See Fig. J1)
upward. Mount the rip fence onto the saw so that the
side with the indicator is on the scale side of the saw
(See Fig. J2). Start by sliding the front of the rip fence
onto the front side of the table so that the front locking
plate contacts the front side of the table then push
down on the back of the rip fence so that the fence
is level on the table. Be sure both locking plates are
in contact with both the front and back edges of the
table. (See Fig. J3)
ENGLISH • 21
H4
I
J1