Toshiba MMK-AP0157HP-E Service Manual page 112

No. Part name
Heat exchanger
13
(Evaporator)
Procedures
Cross flow fan
3.5 mm
Set screw
- Holding the set screw, install the
cross flow fan so that flat area on shaft of
the fan motor comes to the mounting hole
of the set screw.
1) Follow the procedure in item 3 and 4 .
2) Remove 3 fixing screws at the upper left
side of the heat exchanger.
3) Remove 2 fixing screws at the upper and
right side of the heat exchanger.
4) Remove the pipe holder from the rear side
of the main unit.
5) ) Pull out the heat exchanger to upper side.
Heat exchanger
<To re-installation>
- Keep the back body horizontally and put the
heat exchanger carefully to the back body.
- Make sure the heat exchenger can be
assembled with the back body and secure it
tightly with screws.
Body back
Fan motor
Back body
- 112 -
FILE NO. SVM-18070
Remarks
Heat exchanger
Screw
Screw
Heat exchanger
Screws
Pipe holder