Receiver Settings; Configuring A Linear Receiver For Automatic Switching - KVH Industries TracVision TV1 User Manual

Configuring a Linear Receiver for Automatic
Switching
For automatic satellite switching to work properly using the DiSEqC
communication protocol, you need to set up your receivers for the
same satellites you installed in the TracVision antenna. Be sure to set
up the satellites in the receiver in the exact same order as they were set
up in the antenna. The specific setup process varies among receiver
models – refer to your receiver owner's manual for details. Use the
table and figure below as a guide.
Satellites in Antenna
Slot A
Slot B
Slot C
Slot D
Figure 5-1 Linear Receiver DiSEqC Settings (Example)
Matching Satellites in Receiver
Port/Switch/LNB/DiSEqC 1 or A
Port/Switch/LNB/DiSEqC 2 or B
Port/Switch/LNB/DiSEqC 3 or C
Port/Switch/LNB/DiSEqC 4 or D
TracVision TV1 User's Guide

Receiver Settings

35