Gear Pump Service - Toro Groundsmaster 4100-D Service Manual

Gear Pump Service

21 to 24 ft- -lb
(29 to 33 N- -m)
21 to 24 ft- -lb
(29 to 33 N- -m)
1. Shaft seal
2. Washer
3. Cap screw (8 used)
4. O- -ring
5. Washer (8 used)
6. Proportional valve
7. Plug
8. Plug
9. O- -ring
10. Front body
Disassembly (Fig. 44)
Work in a clean area as cleanliness is extremely impor-
tant when repairing hydraulic pumps. Thoroughly clean
the outside of pump. After cleaning, remove port plugs
and drain oil from pump.
1. Scribe a line, at an angle, across front plate (15), bo-
dies (10, 19, 26), adapter plates (23, 24) and backplate
(27). This will assure proper reassembly.
Hydraulic System
13
11
12
10
4
17
18
19
4
20 21
28
29
27
4
6
Figure 44
11. Drive gear assembly
12. Wear plate
13. Pressure seal
14. Backup gasket
15. Front plate assembly
16. Idler gear
17. Key
18. Drive gear
19. Middle body
20. Drive gear
Page 4 - - 54
5
4
8
14
4
16
14
13
12
22
4
25
26
NOTE: To maintain maximum pump efficiency, keep
body, gears and wear plates for each section together.
DO NOT mix parts between different sections.
IMPORTANT: Avoid using excessive clamping
pressure on the pump housing to prevent distorting
the housing.
2. Clamp pump in vise, shaft end up and remove the
eight cap screws (3).
3
1
25 to 28 ft- -lb
2
(34 to 38 N- -m)
15
23
24
9
7
21. Idler gear
22. Key
23. Front adapter plate
24. Rear adapter plate
25. Idler gear
26. Rear body
27. Backplate assembly
28. Plug
29. O- -ring
Groundsmaster 4100--D