Toro Groundsmaster 4100-D Service Manual page 234

NOTE: Installation of clevis pins to deck and height−of−
cut chains is easier if deck is lifted slightly.
4. Install clevis pins and hairpins that secure the
height−of−cut chains to the rear of the cutting deck (Fig.
2).
5. Install wing deck lift cylinders to cutting deck (Fig. 4):
A. Thoroughly clean tapered surfaces of lift cylinder
studs and mounting bosses on deck.
B. Position lift cylinders to the deck.
C. Secure the barrel end of each lift cylinder to the
center deck with flange nut and flat washer. Torque
flange nut from 160 to 180 ft−lb (217 to 244 N−m).
D. Make sure that spacers are positioned on each
side of the lift cylinder clevis. Install cap screw from
the front side of the deck and secure each lift cylinder
clevis to the wing deck with lock nut. Torque lock nut
from 160 to 180 ft−lb (217 to 244 N−m).
6. Connect cutting deck wire harness to main machine
wire harness (Fig. 5).
7. Position dampers to lift arms. Install clevis pins and
hairpins to secure dampers to lift arms (Fig. 3).
8. Install any removed cutting deck covers.
9. Install hydraulic motors to cutting deck (see Cutting
Deck Motor Installation in the Service and Repairs Sec-
tion of Chapter 4 − Hydraulic Systems).
10.Lubricate grease fittings on cutting deck and lift as-
semblies (see Operator's Manual).
Cutting Deck
1. Cutting deck wire harness connection
Page 8 − 8
1
Figure 5
Groundsmaster 4100−D