Main Burner Ignition & Usage; Main Burner Ignition; To Extinguish - Weber Summit 460 Installation Manual

MAIN BURNER IGNITION

Summary lighting instructions are inside the left-hand cabinet door .
m DANGER
Failure to open the lid while igniting the grill's burners, or
not waiting five minutes to allow the gas to clear if the grill
does not light, may result in an explosive flare-up which can
cause serious bodily injury or death.
Main Burner Snap Ignition
Note: Each control knob snap igniter creates a spark from the igniter electrode to the
burner lighting tube. You generate the energy for the spark by pushing in the control
knob and turning it to START/HI. This will ignite each individual burner.
m WARNING: Check hose before each use of grill for nicks,
cracking, abrasions or cuts. If the hose is found to be
damaged in any way, do not use the grill. Replace using
only Weber authorized replacement hose. Contact the
®
Customer Service Representative in your area using the
contact information on our web site.
Log onto www.weber.com.
A) Open the lid (1) .
B) Make sure all burner control knobs are turned off (2) . (Push control knob in and turn
it clockwise to ensure that it is in the OFF position .)
m WARNING: The burner control knobs must be in the OFF
position before turning on the liquid propane tank tank
valve. If they are not in the OFF position, when you turn on
the LP tank valve, the "excess gas flow control" feature will
activate, limiting the flow of gas from the LP tank. If this
should occur, turn off the LP tank valve and burner control
knobs. Start over.
m DANGER
When the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. After
turning off the tank and burner control knobs, wait at least
five minutes for the gas to clear before attempting to light
the grill. Failure to do so may result in an explosive flare-up,
which can cause serious bodily injury or death.
C) Turn the LP tank on by slowly turning the tank valve counterclockwise; wait 60
seconds (3) .
m WARNING: Do not lean over the open grill.
D) Push the control knob in and turn it to START/HI until you hear the igniter snap (4);
continue to hold control knob in for two seconds . This action will spark the igniter,
the burner lighting tube, and then main burner .
E) Check that the burner is lit by looking through the cooking grates (5) . You should see
a flame . If burner does not light on first try, push control knob in and turn it to OFF .
Repeat lighting procedure a second time .
m WARNING: If the burner still does not light, turn the burner
control knob to OFF and wait five minutes to let the gas
clear before you try again or try to light with a match.

TO EXTINGUISH

Push in and turn each burner control knob clockwise to OFF position . Turn gas supply off
at the source .
◆
16
MAIN BURNER IGNITION & USAGE
◆
OFF START/HI
1
5
2 4
The grills illustrated
in this Owner's Guide
may vary slightly from
the model purchased .
2
MEDIUM
3
4
LOW