Weber Summit 460 Installation Manual page 33

CONNECT GAS SUPPLY
A 58" (147.32 cm) corrugated gas line is connected to the manifold of the grill.
A) The main corrugated line passes through the "island" structure cavity to the hose
and regulator connection inside the tank enclosure (1).
B) Uncap the flare fitting from the 90° connection on the regulator hose located inside
the tank enclosure (2).
C) Connect the main corrugated hose to the 90° bulkhead fitting. Use the
(12.7 mm) flared gasket to ensure proper seal (3).
Note: ⁄ " flared gaskets come with the LP tank enclosure kit included with your
1
2
Summit® Built-In Gas Grill. Only use the
the optional side burner.
If you choose to use a corrugated gas line other than the one supplied, the connector
must comply with the Standard for Connectors for Outdoor Gas Appliances and
Manufactured Homes, ANSI Z21.75*CSA 6.27, and be suitable for outside installation.
The maximum length of this connection shall be 6 ft (1.82m).
If the tank enclosure has a door, the connector must be visible when the door is open.
Any piping, flexible tubing, or gas connector within the built-in enclosure must be
supported.
Any opening(s) in a compartment in the built-in enclosure through which piping, flexible
tubing, or gas connectors pass, must have a bushing or some other means to prevent
chaffing.
◆
GAS SUPPLY CONNECTION
⁄ "
1
2
⁄ " (9.53 mm) flared gasket if you are installing
3
8
CONNECTION CHART
1
6
7
8
5
4
Typical tank cabinet or tank enclosure location
5
6
7
8
Corrugated gas line to manifold
9
10 ⁄ " (13 mm) flared gasket
1
2
11
Cap (optional side burner)
4
3
9
10 2
11
Side view
Top of box
Back of box
90° fitting
WWW.WEBER.COM
® 33