Ariens Sno-Thro 921023 – Deluxe 28 Track Owner's/Operator's Manual page 25

Control
Lever Nut
Figure 19
If deflector does not follow full range of travel:
1. Push deflector remote forward.
2. Loosen adjusting nuts on cable support
bracket on side of chute deflector.
(Figure 20).
Figure 20
To adjust the deflector lower:
1. Slide cable up and tighten top nut.
To adjust deflector higher:
1. Slide cable down and tighten bottom nut.
Check travel and repeat adjustment as
necessary.
DISCHARGE CHUTE CONTROL
(Figure 21)
If discharge chute does not stay in position
while operating, tighten nut on carriage bolt at
pivot point to increase tension on spring.
1
1. Spring
2. Nut
SPEED SELECTOR
ADJUSTMENT
(Figure 22)
To adjust:
Adjustment
Nuts
EN - 25
2
Figure 21
1. Disconnect adjustment pivot pin from
speed selector lever by removing
hairpin.
2. Place the speed selector on the control
panel in the fastest forward speed
position.
3. Turn the speed selector lever straight
down towards the ground as far as it will
go.
4. 921023: Thread the adjustment pivot pin
along the shift rod until it aligns with the
mating hole on the speed selector lever.
Insert the pivot pin into hole.
921024, 030, 032: Thread the
adjustment pivot pin along the shift rod
until it aligns with the mating hole on the
speed selector arm and turn up the shift
rod seven turns. Insert the pivot pin into
the hole.
5. Secure adjustment pivot pin with hairpin.
6. Make sure the speed selector shifts into
each speed position.
7. Check forward and reverse speeds:
a. Start unit.
b. Shift speed selector into the first
forward speed.
c. Engage the traction drive clutch.
Unit should move forward.
d. Stop unit.
e. Shift speed selector into first
reverse speed.