Table of Contents
Advertisement
6. Run coax from the antenna unit to the roof edge, then along edge to location where coax will
be fed into the vehicle. If installing an optional second receiver, run second coax to location
where it will enter the vehicle. Secure (both) coax to roof every 12-18 inches (see below).
through hole. Seal opening with roof compatible sealant so that it is completely waterproof
8. Inside vehicle, connect coax cable(s) to the appropriate receiver(s).
IMPORTANT!
to length but you must
Snap-n-Seal Connectors.
9. Go to KING TAILGATER OPERATION Section.
IMPORTANT!
Roof hole(s) for wiring must be sealed
so they are completely waterproof.
Sealant must be roof compatible.
Page 21
Advertisement
Table of Contents
