Table of Contents
Advertisement
– Inverter Multi Split System Air Conditioner –
This air conditioner uses the new refrigerant R410A.
Contents
IMPORTANT!
Please Read Before Starting .................................. 2
1.
GENERAL .......................................................... 3
1-1. Tools Required for Installation (not supplied)
1-2. Accessories Supplied with Unit
1-3. Optional Copper Tubing Kit
1-4. Type of Copper Tube and Insulation Material
1-5. Additional Materials Required for Installation
2.
INSTALLATION SITE SELECTION ................... 4
2-1. Indoor Unit
2-2. Connecting Indoor Units
2-3. Outdoor Unit
2-4. Outer Dimensions of Outdoor Unit
2-5. Diagram of Outdoor Unit Installation
3.
INSTALLATION PROCESS ............................... 8
3-1. Embedding the Tubing and Wiring
3-2. Drain Cap and Drain Elbow
3-3. Use of the Flaring Method
3-4. Flaring Procedure with a Flare Tool
3-5. Caution Before Connecting Tubes Tightly
3-6. Tubing Connections
3-7. Insulation of Refrigerant Tubing
3-8. Taping the Tubes
3-9. Finishing the Installation
4.
AIR PURGING................................................... 11
I Air Purging with a Vacuum Pump (for Test Run)
I Pump Down
5.
WIRING INSTRUCTIONS ................................ 14
5-1. General Precautions on Wiring
5-2. Recommended Wire Length and Diameter
5-3. Wiring System Diagram
5-4. How to Connect Wiring to the Terminal
5-5. Wiring Instructions for the Outdoor Unit
6.
TEST RUN......................................................... 18
7.
CONNECTING A HOME AUTOMATION
DEVICE ............................................................. 19
8.
INSTALLATION CHECK SHEET ...................... 19
9.
ELECTRIC WIRING DIAGRAM ........................ 19
456
85264190
001 © SANYO 2008
INSTALLATION INSTRUCTIONS
Page
Model Combinations
Combine indoor and outdoor units only as listed
below.
Indoor Unit
SAP-KMRV74EH
SAP-KMRV94EH
SAP-KMRV124EH
SAP-KMRV76EH
SAP-KMRV96EH
SAP-KMRV126EH
SAP-KRV96EHDS
SAP-KRV126EHDS
Combine indoor and outdoor units only as listed in
the combination tables for 2-room outdoor unit as
shown in its respective manual.
Power Source:
50 Hz, single-phase, 220 – 240 VAC
Be sure to read the yellow instruction sheet
attached to the outdoor unit for models using the
new refrigerant R410A.
Combination example
Indoor unit B
Indoor unit A
Outdoor unit
NOTE
The illustrations are based on the typical appearance of
a standard model. Consequently, the shape may differ
from that of the air conditioner that you are installing.
For Outdoor Unit
COOL / DRY/ HEAT Model
Outdoor Unit
SAP-CMRV1426EH
SANYO Electric Co., Ltd.
Osaka, Japan
Hide quick links:
Advertisement
Table of Contents
